Toggle navigation
Home
Videos
All
New
Search
Categories
Popular Categories:
2000 Series
3000 Series
Recorders
Resources
Tutorials
Contact
Buy
Configuring iTools Software to Communicate Via a Serial Connection
Video Info
Transcript
Category:
Recorders
Views:
3394
Description:
How to configure the iTools Software to work via a Serial Connection.
Keywords:
itools, serial, modbus, rtu, , 2216, 2208, 2204, 2416, 2408, 2404, 3216, 3204, 3504, 2604, 2704
This Video Tutorial will show you how to setup the Eurotherm iTools Software to communicate via Serial Modbus RTU protocol.
First we must begin by clicking on the START button at the bottom left corner of your desktop.
Next navigate to Settings -> Control Panel Icon and click on this icon.
Next navigate to the iTools icon and double click on this.
This will pop up the Registry Settings – iTools Configuration window.
Navigate to the Serial Ports tab and single click on this tab. This will bring you to the Configure Serial ports section.
Navigate and check the box next to the serial communications port that is active on your PC. For this tutorial Com 3 is the active serial port.
Next click on the EDIT button at the bottom right side of this window.
Make sure the Enabled box at the top is checked off and the parameters are setup as noted.
Next click on the OK button.
Then click on the APPLY button.
Then click on the OK button.
iTools is now setup to communicate via Serial Modbus RTU Protocol.